Interface Configurations

Interface Configurations
After VTP and VLAN assignments have been made, you can finally enable MLS on the interface.
This is done with the same command that was used to globally enable MLS: mls rp ip,
as in this example:
Terry_2620#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Terry_2620(config)#interface fastethernet 4/0
Terry_2620(config-if)#mls rp ip
Terry_2620(config-if)#^Z
Terry_2620#
!
interface FastEthernet4/0
ip address 172.16.10.1 255.255.255.0
no ip directed-broadcast
no ip route-cache
no ip mroute-cache
mls rp vtp-domain test
mls rp vlan-id 10
mls rp ip
!