The ip audit po remote Command

Use the global configuration mode command ip audit po remote to specify one or more sets of Post Office parameters for Cisco Secure IDS Director(s) receiving event notifications from the router. A router can report to more than one Director by adding an ip audit po remote command for each Director. Use the no form of this command to remove a Director’s Post Office parameters as defined by host ID, organization ID, and IP address. The syntax is

Rtr1(config)# ip audit po remote hostid host-id orgid org-id rmtaddress ip-add localaddress ip-add [port port-num] [preference pref-num] [timeout seconds] [application {director | logger}]

This command was introduced in IOS 12.0(5)T. The default organization ID is 1, the default host ID is 1, the default UDP port number is 45000, and the default preference is 1. The default heartbeat timeout is five seconds.