Feb 15,2010 by alperen
Use the following commands to verify that failover configuration is correct.
show failover Use the show failover command to verify the status of the connection and to determine which unit is active. You saw sample output earlier in this section.
show failover [lan [detail]] The show failover lan command displays the LAN-based failover information useful for debugging purposes.
pix(config)# show failover lan Lan Based Failover is Active interface lanlink (192.168.3.1): Normal, peer (192.168.3.2): Normal
The show failover lan detail command displays the connection details, as well as traffic summary information.
pix(config)# show failover lan detailLan Failover is ActiveThis Pix is PrimaryCommand Interface is lanlinkPeer Command Interface IP is 192.168.3.2My interface status is 0x1Peer interface status is 0x1Peer interface downtime is 0x0Total msg send: 103093, rcvd: 103031, droped: 0, retrans: 13, send_err: 0Total/Cur/Max of 51486:0:5 msgs on retransQmsgs on retransQ if anyLAN FO cmd queue, count: 0, head: 0x0, tail: 0x0Failover config state is 0x5cFailover config poll cnt is 0Failover pending tx msg cnt is 0Failover Fmsg cnt is 0 cp22 password
Sections
Syndication
