Destination Switch Configuration
On a destination switch, the destination port is configured
this way:
Sw4000-4> (enable) set rspan destination 4/1 123
Rspan Type : Destination
Destination : Port 4/1
Rspan Vlan : 123
Admin Source : -
Oper Source : -
Direction : -
Incoming Packets: disabled
Learning : enabled
Multicast : -
Filter : -
RSPAN sessions can be disabled on source switches by using:
Sw4000> (enable) set rspan disable source all
This command will disable all remote span source session(s).
Do you want to continue (y/n) [n]? y
Disabled monitoring of all source(s) on the switch for remote span.
Or, for a specific session, identified by RSPAN VLAN number:
Sw4000> (enable) set rspan disable source
Sessions can also be disabled on destination switches using
Sw4000> (enable) set rspan disable destination all
This command will disable all remote span destination session(s).
Do you want to continue (y/n) [n]? y
Disabled monitoring of remote span traffic for all rspan destination ports.
Or, for a specific session identified by a port number:
Sw4000> (enable) set rspan disable destination
Sections
Comments (0 posted)
Syndication
