Configuring the Connection from SW4 to SW2

Configuring the Connection from SW4 to SW2

SW4#show run interface GigabitEthernet1/1

Building configuration...



Current configuration : 36 bytes

!

interface GigabitEthernet1/1

end



SW4#config t

Enter configuration commands, one per line.  End with CNTL/Z.

SW4(config)#interface GigabitEthernet1/1

SW4(config-if)#no switchport

SW4(config-if)#ip address 172.16.240.21 255.255.255.252

SW4(config-if)#end

SW4#

The connection is completed by configuring the GigabitEthernet1/2 interface on SW2, as shown in Example 7-35.